3-48
(7)
PH HEIGHT ADJ
Used to adjust the Print head height. (
P.2-
36 [Change the Print head height]
)
(8)
RESEAT PRINT HEAD
Check the poor contact of connector connec-
tion, based on the message.
(9)
PH WARM
Head warming-up is used to warm up the
Print head. When the temperature inside the
printer is low, head warming-up is automati-
cally started immediately before printing. Use
the head warming-up to warm up the Print
head in advance before printing.
(1) When head warming-up is executed, the
message is displayed as shown on the
right side.
(2) When the Print head temperature reaches
to a certain level, the message is dis-
played as shown on the right side. Head
warming-up finishes after the carriage
moves to operate several scanning (and
also feeding the media by few cm).
#RESEAT PRINTHEAD
>
#PH HEIGHT ADJ
>
#PH WARM
>
#PH WARM
*PH WARMING UP XXm
#PH WARM
*EXECUTING
XX : Time required to finish the head
warming-up
IP-5610取説_E.indb 48
09.4.3 3:14:48 PM
