2-37
2
Ba
sic O
pe
ra
tio
n
6
Switch the height of Print head with the head up down mechanism.
¯
[High] is 0.5 mm higher than [Normal].
[Normal] should be used in most situations.
7
Tighten two (2) fixing screws.
Note
-
Do not move the head up down mechanism with the head securing screws
tightened. The head up down mechanism may be broken.
-
When changing the height of Print head, tighten the head securing screws while
pushing lightly the carriage downward.
-
When changing the height of Print head, change [PH HEIGHT VAL] in the MEDIA
REG MENU also. (
P.3-31[(18) PH HEIGHT VAL]
-
The print shift may occur in the bi-directional print after changing the height of
Print head. If this is the case, adjust the bidirectional position in [BIDIR ADJ] of the
MEDIA REG MENU.(
P.3-32 [(19) BIDIR ADJ1 L] to [(24)BIDIR ADJ3 R]
-
As the gap between the side plate of printer and the carriage is narrow, if it is
hard to reach the head up down mechanism and head securing screws, move the
carriage to the right (or the left) by hand.
-
Confirm that the head securing screws at right and left are tightened. If the head
securing screws on the carriage loosen, they may strike the media or edge guard,
causing poor image quality and damage to the printer.
During adjustment of the head height, the warning beep will be heard.
(
P.3-56 [(6) BEEP]
)
High (For thick media)
Normal (For normal (thin
(normal thickness) media)
IP-5610取説_E.indb 37
09.4.3 3:14:19 PM
