2-28
Cut the media
This section describes the procedure to cut the media manually.
- Shift the blower unit to prevent any interference with the operation.
1
Clip both ends of media with the media
clip.
2
Move the Media cutter blade and cut the
media.
- The arrow mark (
g
) is imprinted on the Media
cutter blade.
The Media cutter blade can only cut in the
direction of the media in the arrow mark (
g
).
If the arrow mark (
g
) is not oriented in the
cutting direction, change the orientation in the
procedure below.
1
Hold the side of Media cutter blade by
hand and pull it out.
2
Rotate the Media cutter blade so that the
left side comes to the right side and then
insert it.
Note
-
If the Media cutter gets stuck while cutting, return the cutter blade to the side and
check it is not broken. Remove the cause of the binding and cut the media, slowly
moving the Media cutter blade. Some medias are hard-to-cut . Do not forcibly cut
difficult media. Doing so may be break the blade or cutting performance may be
degraded.
- If you drop the Media cutter blade, the blade of Media cutter blade may break,
resulting in poor cutting performance. Handle it with care.
- When cutting, cut debris may be produced. The cut debris may contaminate the
printed surface or cause poor cutting.
Arrow
IP-5610取説_E.indb 28
09.4.3 3:14:12 PM
