3-36
(30) HEATER PREF
Select the heater preference.
<Parameter (numeral input)>
SOFTWARE
Data (print mode) sent from RIP of computer is the controlling
source
HEAT PANEL
The print mode set in the MEDIA REG MENU of printer is the
controlling source.
(31) PH REST PERIOD
Scanning of printer head rests at a certain print
length interval while printing.
Use this setting to prevent loss of printed data
during a print. Normally, set it to [0000CYCLES].
- Set the number of scan for print length in the [(31) PH REST PERIOD].
- Set the rest time in the [(32) PH REST TIME].
<Parameter (numeral input)>
0000 to 9999
[0] does not perform the scan rest.
(32) PH REST TIME
Corresponding to [(31) PH REST PERIOD], set
the rest time. When [0] is set in [(31) PH REST
PERIOD], this parameter is ignored.
Use this setting to prevent the lost print data
from occurring. Set it to [10 sec] as a general
rule.
<Parameter (numeral input)>
1 to 99 seconds
#PH REST TIME
>XX:10sec
#PH REST PERIOD
>XX:0000CYCLES
XX : Selected media number
XX : Selected media number
#HEATER PREF
>XX:SOFTWARE
XX : Selected media number
IP-5610取説_E.indb 36
09.4.3 3:14:45 PM
