3-29
O
pe
ra
tio
n p
an
el o
f m
en
u o
pe
ra
tio
n
q
Explanation of each menu operation
3
(11) LEADING EDGE
Detects the edge of the media when replac-
ing or setting the media, and selects whether
the media should be returned to the waiting
position.
When the take-up reel unit used, the media
will not be returned to the waiting position
regardless of this setting.
<Parameter (selection input)>
NORMAL
Detects the media width when replacing or setting the
media, and then completes the media setting after checking
media skew during media feeding.
DEDUCED
Detects the media width at replacing or setting the
media
and then completes the media setting after detecting the
edge of the media during media rewinding.
Note
Usually set [NORMAL] when selecting [REDUCED,] take care of the followings.
- Cut the edge of the media so that the edge of the media is parallel to the guide
line and set it to the printer.
If the edge of the media is not parallel, the print is missed on the edge of the
media and the platen is stained by ink and the media jam is caused.
- Set the media after checking no tape or glue or the edge of the media. If using
the media with tape or glue, it causes media jam.
(12) VACUUM LEVEL
Select the force (speed of fan) to draw the
media to the platen.
<Parameter (selection input)>
NORMAL
Draws the media by normal amount of force.
LOW
Draws the media by with less than normal amount of force.
Note
-
When thin media (cloth) wrinkles, select [LOW].
-
When [LOW] is selected, the airflow of the blower unit also becomes low.
#LEADING EDGE
>XX:NORMAL
XX : Selected media number
#VACUUM LEVEL
>XX:NORMAL
XX : Selected media number
IP-5610取説_E.indb 29
09.4.3 3:14:42 PM
