Operating Instructions
Chapter
10
Flexi Classic Gateways
8011834/YT28/2016-03-15
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
129
Subject to change without notice
PROFINET IO Gateway
10.4
PROFINET configuration of the gateway — which data
are transferred
10.4.1
Cyclic data
The physical Flexi Classic IO modules are not represented as typical hardware modules in
the PROFINET IO hardware catalogue. Instead, the data available from the Flexi Classic
system has been organized into data sets. Each data set represents a “hardware” module
in the PROFINET IO hardware catalogue. The Flexi Classic PROFINET IO gateway device
supports four slots where the modules can be placed into. This allows each data set to be
mapped once.
Data set 1
Data set 2
Data set 3
Data set 4
Input data
Input data
Input/output data
Input data
WORD 1
SEQ SEQ SEQ SEQ
Byte 3
MED1 MQD1 DIG_OUT1
BAS1
Byte 4
MED2 MQD2 DIG_OUT2
Backplane
fault
Byte 5
MED3 MQD3
CRC1
Byte 6
MED4 MQD4
CRC2
Byte 7
MED5 MQD5
Byte 8
MED6 MQD6
Byte 9
MED7 MQD7
Byte 10
MED8 MQD8
Byte 11
MED9 MQD9
Byte 12
MED10 MQD10
Byte 13
MED11 MQD11
Byte 14
MED12 MQD12
Byte 15
MED13 MQD13
Length
15 bytes
15 bytes
4 bytes
6 bytes
Drag the modules from the SIEMENS SIMATIC Manager — HW Config hardware catalo-
gue under
>>PROFINET IO > Additional Field Devices > Gateway > SICK > Flexi
Classic... > data sets
into the slots of the UE410
F
EN4 shown in the SIEMENS SIMATIC
Manager — HW Config configuration table.
The I and Q addresses reflect where in memory the cyclic data will be available.
Each data set can only be placed in the slot of the same number.
Tab. 114: Data set 1-4 of the
UE410
0
EN
Fig. 21: Projecting the
UE410
0
EN4
Notes