8017035/ZMO9/2017-06-08 • © SICK AG • Subject to change without notice.
97
Functions
Width
The largest distance from the rightmost point to the leftmost point that
cross the center of the area's height is output.
Use this function when you want to find the widths of protrusions and gaps.
Tips: • The points that are detected by the width function are the positions
that are detected by “Edge pos.”
P pos
The position of the highest measured value within the area is output.
Tips: • If there is an alarm within the area, the measured result will indicate
that measurement is not possible.
• Within the range of the area, if there are measured values that are
larger than the area, the measured result will indicate that measurement
is not possible.
• If there are multiple positions that are all the maximum value, the leftmost
position will be output.
•
The peak is determined by comparing the sizes of the measured values,
so when “Axis dir” is set to “Far+,” the peak will be in relation to the lower
part of the screen.
B pos
The position of the smallest measured value within the area is output.
Tips: • If there is an alarm within the area, the measured result will indicate
that measurement is not possible.
• Within the range of the area, if there are measured values that are smaller
than the area, the measured result will indicate that measurement is not
possible.
• If there are multiple positions that are all the minimum value, the leftmost
position will be output.
•
The bottom is determined by comparing the sizes of the measured values,
so when “Axis dir” is set to “Far+,” the bottom will be in relation to the
upper part of the screen.
