8017035/ZMO9/2017-06-08 • © SICK AG • Subject to change without notice.
99
Functions
• Direction
Select the direction in which to perform the mathematical area
measurement from “
↑
” (from the lower side of the area up) and “
↓
”
(from the upper side of the area down) in relation to the specified height.
The measurement areas for each of these settings are shown below.
(The arrows indicate the set mathematical area directions and the shad-
ed-in parts indicate the measurement areas.)
Tips: • Mathematical area measurement results have up to three decimal plac-
es. The fourth decimal place is zero (0).
Length
The line length of the profile within the area is determined.
The unit of the output value is length (mm).
Tips: •
Because the line length is the same for the same profile,
this function can be used to perform profile judgment.
Diameter
An approximate circle is determined from the measured values within
the area, and then the diameter of this circle is output.
The unit of the output value is length (mm).
R
• Direction
Select the direction in which to perform the measurement from “
↑
”
(from the lower side of the area up) and “
↓
” (from the upper side of the
area down). Indicate the convex direction of the arc to measure.
