Setup and Measurement Procedures
18
© SICK AG • Subject to change without notice. • 8017035/ZMO9/2017-06-08
4 Setup and Measurement Procedures
4.1
Before Using the Profiler 2
4.1.1
Procedure for Using the Sensor
Before you use the Profiler 2, install and setup the sensor according
to the procedure shown below.
1. Installation and light
axis adjustment
Install the sensor such that you can perform accurate measurements
of the measurement target.
Reference: For details on the installation of the sensor, see “3.4 Installation.”
2. Wiring
Connect the cables.
3. Settings
Configure the settings related to measurement. You can use one of the
following methods to configure the settings.
1. Sensor
• Configure all the settings from the Profiler 2.
2. PRO2-Navigator
• Use the dedicated PRO2-Navigator setup software to intuitively
view and change all the settings.
3. Serial communication
• Use RS-485 communication to view and change all the settings
of the Profiler 2.
4. Measurement
Perform measurements.
With the Profiler 2, measurement results can be output using one of the
following methods.
1. Judgment output (control output)
• The Profiler 2 is equipped with three judgment outputs (control outputs).
2. Analog current output (4 to 20 mA)
3. Serial communication (RS-485 communication)
4. PRO2-Navigator (monitor display of measured values)
Tips: •
Serial communication or PRO2-Navigator is required to output and check
stored data.
