Functions
102
© SICK AG • Subject to change without notice. • 8017035/ZMO9/2017-06-08
Area 1
—
Area 2
Area 1
Area 2
Calculation formula
Area settings
(Average height)
(Average height)
To perform an angle measurement, measure the angles of the two
components that make up the angle that you want to measure, and then
subtract one angle from the other. When a measurement is performed
with the following formula, the outer angle of the gap or protrusion is
output. To output the inner angle, set “180” for the offset value.
7.8
Output Settings
7.8.1
Out target
Select the output target area.
[Setting target:] Outputs 1 to 3 and analog output
Select the target from the following parameters.
• Area1
}
The measured result of the area is set as the output
target.
• Area2
• Area3
• Area4
• Calc1
}
The calculation result is set as the output target.
• Calc2
The illustrations shown in the explanations are when "Out polar" is set to "N.O." and "On Timing" is set to "Out
range".
7.8.2
Thresholds and Output
[Setting target:] Outputs 1 to 3
