Functions
92
© SICK AG • Subject to change without notice. • 8017035/ZMO9/2017-06-08
V correct
Sets the reference position. The height is adjusted so that it is equal
to the height of this position.
1. Set the reference position.
Set the reference position, corresponding to the master image, at which
correction will be performed. The height will be corrected so that it becomes
the same as that of the measured value at this position.
2. Perform measurements.
Measure the height at the reference position on the measured profile.
3. Perform corrections.
The area will be corrected by the amount of the height difference between
the master image and the measured profile.
Tips: •
If you specify a position at which an alarm occurs on the master profile,
the height correction is not performed.
•
If an alarm occurs at the specified position during measurement, meas
-
urement is performed without correction.
