Functions
106
© SICK AG • Subject to change without notice. • 8017035/ZMO9/2017-06-08
Tips: •
“Offset” and “Offset value” operate on areas and calculations.
Therefore, the values of any other calculations or outputs that are
referencing the area or calculation in question will also be changed.
In the above figure, if the offset operation is executed on output 1
(the dotted line on the left side of the figure), the values of calculation
1 and output 3 — which are referencing area 1 — will also be changed.
•
Thresholds are judged based on the offset value.
For example, output will turn on as shown below when the offset value is
100 mm and the upper limit is 10 mm. Offset value (100 mm) + Upper
limit (10 mm) = 110 mm
(Refer to the figure to the right. Changing the offset value will shift the
upper and lower limit accordingly.)
0
Offset value
Upper limit
Lower limit
