Functions
98
© SICK AG • Subject to change without notice. • 8017035/ZMO9/2017-06-08
Edge pos
The rightmost point or the leftmost point that crosses the center
of the area's height is output.
• Detection direction
Specify the direction from which to detect edges.
The figure to the right shows the detection result when detection from
the left is specified.
12
6
5
4
3
EdgeCount
The number of times that the profile crosses the center of the area's height
will be counted.
Tilt
A straight line approximating the profile within the area is determined,
and then the tilt of this straight line is measured.
The unit of the output value is degrees (°).
Tips: • If there is data for which measurement is not possible within the area,
the measured result will indicate that measurement is not possible.
•
In order to perform the tilt measurement, the profile must cross the left
and right sides of the area (the thick-bordered frame). If the profile does
not cross both sides, the measured result will indicate that measurement
is not possible.
•
To measure the angle, you have to use the “Calc” function.
Size
The mathematical area of the section bounded by the profile and the
specified height within the area is determined.
The unit of the output value is mathematical area (mm
2
).
