Sharp MX-M623, Operation Manual, Page: 73 / 877

1-32
BEFORE USING THE MACHINE
Contents
LOADING PAPER IN PAPER TRAY 3
Approximately 500 sheets of standard paper (20lbs. (80 g/ m
2
)) from 11" x 17" to 5-1/2" x 8-1/2"R size (A3 to A5R) can be
loaded in tray 3. Special papers such as tabbed paper and transparency film can also be loaded. For information on
what special papers can be used, see "
Types of paper that can be used in each tray " on page 1-28. To load tabbed
paper or transparency film, see " Loading tabbed paper " (page 1-34) or " Loading transparency film " (page 1-35).
4
Repeat steps 1 to 3 to adjust the far
paper guide to the paper size to be used.
Be sure to adjust the far paper guide to the same size as the
near paper guide.
• When removing and attaching the far paper size guide, take care not to hit the front cover of the machine.
• Adjust both the front and back guides. If only one guide is adjusted, skewed feeding and misfeeds may result.
5
Set the paper type and paper size.
For the procedure for configuring these settings, see " Paper Tray Settings " (page 7-13) in the System Settings.
An incorrect paper type or paper size setting may cause automatic selection of the wrong type or size of paper, and result in
a misfeed or otherwise prevent printing.
1
Pull out paper tray 3.
Gently pull the tray out until it stops.
2
Load paper into the tray.
The paper stack must not be higher than the indicator line (no
more than 500 sheets of SHARP standard paper (20lbs.
(80
g/
m
2
)).
To change the paper size, see " CHANGING THE PAPER SIZE
IN PAPER TRAY 3 " on the next page.