SerVision MVG200, Configuration And Management Manual, Page: 236 / 241

SerVision Embedded Video Gateway System Guide
Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 235



Under Preset , click/tap the Up and Down arrows ( and ) until the number you want to assign to the
preset is displayed.



Select Set .
The location is assigned to the preset number.
Recording Status Display
If the unit was configured to display the system's recording status in the monitor (see Display Recording Status ,
page 29), the status is displayed in the lower-right corner of the screen. The status information indicates whether
video recording is functioning properly and, if it is, displays the current recording status of each camera.
When recording is functioning properly, a status message based on the following template is displayed:
HD:OK REC 0[WP:]X0 1[WP:]X1 2[WP:]X2 3[WP:]X3
The template contains the following items:
Item Description
HD:OK Hard drive is functioning properly (status: OK)
REC Recording is functioning properly
0[WP:]X0 Camera 1 recording status
1[WP:]X1 Camera 2 recording status
2[WP:]X2 Camera 3 recording status
3[WP:]X3 Camera 4 recording status
The recording status displayed for each camera has two parts:

WP: appears if write protection is enabled for the camera. Otherwise, it does not appear.

Xi: is the current recording status of the camera. It can be one of the following values:
Recording Status Description
N No recording
C Continuous recording
T Event-triggered recording: recording is not currently underway
W Event-triggered recording: recording of the pre-alarm part is underway
w Event-triggered recording: recording of the Event, and/or of the post-alarm
part, is underway
For example,
HD:OK REC 0C 1WP:C 2T 3N
means that four cameras are connected to the unit, all four are
recording as configured, and their recording statuses are as follows:

Camera 1: Continuous

Camera 2: Continuous and write-protected

Camera 3: Event-triggered (no recording is underway)

Camera 4: No recording