ROPA Tiger 6, Original Operating Manual

Page: 252 / 564

Operation
Lifter
252 / 564
6.14.1 Setting depth-control wheel speed
Depth-control roller rpm
Choose this function with R-Select.
The ratio of depth-control shaft rota-
tional speed to the driving speed can
be adjusted, pressing key
+
or
-
on the
operating panel.
+ Key = depth-control shaft faster
- Key = depth-control shaft slower
If the key + is released after the stage 10 is reached and then pressed for at least
three seconds, the "Max" stage is reached. The highest hydraulic drive speed is
achieved in the "Max" stage.
In the stage "STOP", the depth-control shaft freely runs on the ground without being
driven.
In stages 1-10, the depth-control shaft runs on the ground with increasingly higher
speed than the current driving speed of the machine.
To keep wear of the depth-control wheels as low as possible, the stage of the depth-
control shaft should always be selected as low as possible. (Recommendation: stage
1 is usually sufficient).
During lifting the speed of the depth-control roller is at least 3 km/h, even for the low-
est depth-control roller stage.