ROPA Tiger 6, Original Operating Manual

Page: 423 / 564

Maintenance and Service
Defoliator
423 / 564
If some other values are displayed, then the central position must be set using the
basic settings for the rod structure.
3
– For this, move the spring rods precisely to the centre of the beet row. This is
located in the centre of the support bracket (indicated with an arrow ( 3 ) to simplify
the work).
– Keep the spring rods fixed in this position.
– Loosen the screws ( 5 ) of the clamping lever left/right for rough adjustment.
5
4
– Shift the bar structure out until roughly the value 0 is shown on the R-Touch.
– Tighten both screws ( 5 ) again.
– Check the value for the central display on the R-Touch. If necessary, set the length
of the bar structure ( 4 ) to the sensor of leaf finder and stop bolts ( 2 ) until the correct
values are shown in the R-Touch.
2
2