Rohde & Schwarz R&S RTM-B1, User Manual

Page: 204 / 854

Applications
R&S
®
RTM3000
204 User Manual 1335.9090.02 ─ 08
Marker value table
There are two markers available for the Bode plot. They are highlighted on the Bode
plot diagram by a white line and the respective marker number 1 or 2. You can move
the markers as needed.
In the marker table you can see the frequency, gain and phase values for both of them
and also the delta values between the two markers.
Remote commands:
●
BPLot:MARKer<m>:DIFFerence:FREQ?
on page 561
●
BPLot:MARKer<m>:DIFFerence:GAIN?
on page 561
●
BPLot:MARKer<m>:DIFFerence:PHASe?
on page 561
●
BPLot:MARKer<m>:FREQuency
on page 562
●
BPLot:MARKer<m>:GAIN?
on page 562
●
BPLot:MARKer<m>:INDex
on page 562
●
BPLot:MARKer<m>:PHASe?
on page 562
●
BPLot:MARKer<m>:SSCReen
on page 562
Vertical position and size of the waveforms
To set the position and the vertical scaling of the gain, phase or amplitude waveforms,
select the waveform and use the vertical [Scale] and [Offset/Position] (upper knob)
knobs.
Remote commands:
●
BPLot:AMPLitude:SCALe
on page 560
●
BPLot:AMPLitude:POSition
on page 560
●
BPLot:GAIN:SCALe
on page 559
●
BPLot:GAIN:POSition
on page 559
●
BPLot:PHASe:SCALe?
on page 560
●
BPLot:PHASe:POSition?
on page 560
8.8.2 Using a Bode Plot
To run a Bode plot measurement
1. Prepare the measurement setup. See "Connecting the test setup" on page 205
2. Start the Bode plot option. See "Starting the Bode plot" on page 205
3. Set the required parameters. See "Setting up the Bode plot" on page 205.
Bode Plot (Option R&S RTM-K36)
www.allice.de Allice Messtechnik GmbH