3
Day of the week. 0: Sunday, 1: Monday
4
The number of the week for the day selected at the 3rd digit. If “0” is selected
for “Sunday”, for example, and the selected Sunday is the start of the 2nd week,
then input a “2” for this digit.
5, 6
The time when the change occurs (24-hour as hex code).
Example: 00:00 (Midnight) = 00, 01:00 (1 a.m.) = 01, and so on.
7
The number of hours to change the time. 1 hour: 1
8
If the time change is not a whole number (1.5 hours for example), digit 8 should
be 3 (30 minutes).
5401
Access Control DFU
These SP's store settings that limit uses access to SDK (Software Development Kit) application
data.
200 SDK1 Unique ID
"SDK" is the "Software Development Kit". This
data can be converted from SAS (VAS) when
installed or uninstalled. DFU
201 SDK1 Certification Method
210 SDK2 Unique ID
211 SDK2 Certification Method
220 SDK3 Unique ID
221 SDK3 Certification Method
5404
User Code Count Clear
Clears the counts for the user codes assigned by the key operator to restrict the use of the
machine. Press [OK] to clear.
5501
PM Alarm Interval
1 Printout
[0 to 9999 / 0 / 1 step]
0: Alarm off
1 to 9999: Alarm goes off when Value (1 to 9999)
≥
PM counter
5504
Jam Alarm Japan Only
5. Service Tables
296
5
Summary of Contents for Neptune-P1
