Ricoh Neptune-P1, Service Manual

Page: 287 / 457

15 Re:Mod5:Ho Recycled Paper: Mode5: Horiz
16 Re:Mod5:Ve Recycled Paper: Mode5: Vert
2923 CBlade Mode Execute Cleaning Blade Replace Mode
Always do this SP after replacing the OPC or cleaning blade.
This SP applies a small amount of toner to the drum and blade to reduce friction between the
new drum and/or new blade. This prevents scratching the drum or bending the blade.
2924 Devr Mix Developer Mixing: Warmup
Enables/disables measurement of Vsg during warm-up immediately after the machine is
switched on. Vsg sampling is done to ensure good quality for the first copies.
[0 to 2/0/1]
0: Vsg is read immediately after the machine is switched on with the fusing temperature less
than 50°C (122°F).
1: Vsg is always read during warm-up immediately after the machine is switched on,
regardless of the fusing temperature level.
2: Vsg is not read during warm-up.
2925 TrCurr Tmg Transfer Current Timing DFU
These SP's adjust the transfer current timing.
1 ON
Adjusts the timing for power on.
[0 to 16/6/0.2 mm]
2 Leading Edge
Adjusts the timing for switching from the leading edge to the center.
[0 to 30/8/1 mm]
3 Trailing Edge
Adjusts the timing for switching from the center to the trailing edge.
[-30 to 0/0/1 mm]
2926 Tnr Over Det Used Toner Overflow Detect
The used toner bottle motor operates a cam. This cam strikes the side of the used toner collection
bottle, to create a vibration that levels the used toner inside the bottle.
1 Sn Detection Used Tnr M (Sensor Detection)
5. Service Tables
286
5