Ricoh Neptune-P1, Service Manual

Page: 95 / 457

• Always make sure that the write-protect switch is OFF before uploading data to an SD card. It is very
easy to accidentally turn on the write-protect switch when inserting and removing an SD card.
• To remove an SD card from its slot, push it in gently to release it then pull it out of its slot.
Application Move
“Move Exec” (SP5873-1) moves one application program from the original SD card to another SD card.
The application program is moved from Slot 3 to Slot 1 (or Slot 2).
1. Turn off the main power switch.
2. Remove the SD card slot cover (

x1).
3. Insert the original SD card with the application in Slot 3.
4. Insert the SD card to receive the application in Slot 1.
• The SD card to receive the moved application can be set in Slot 2, but in this case Slot 1 must
be empty. (The application always moves the application to Slot 1 by default if there are SD
cards in both Slot 1 and Slot 2.)
5. Turn on the main power switch.
6. Enter the SP mode and do SP5873-1 “Move Exec.”
7. Follow the messages on the operation panel to complete the procedure.
8. Exit the SP mode.
9. Turn off the main power switch.
10. Remove the original SD card from Slot 3.
11. Leave the other SD card in Slot 1 or Slot 2.
12. Turn on the main power switch.
13. Check that the application program runs normally.
14. Tell the customer to store the original SD card in a safe place.
1. Installation
94
1