Ricoh Neptune-P1, Service Manual

Page: 43 / 457

SP No. Name
1001-3 Leading Edge Registration – Cassette (B853)
1002-3 Side-to-Side Registration – Cassette (B853)
Bypass Tray Adjustments (Bypass)
SP No. Name
1001-5 Leading Edge Registration – Bypass
1002-5 Side-to-Side Registration – Bypass
Enable Onboard NIB, USB Functions
Do SP5985 (Device Setting) to enable the onboard NIB and USB features built into the GW Controller
board.
• The default setting of SP5985 is "0" (Disable). This SP must be set to "1" in order to use the built-in
NIB and USB functions.
Moving the Machine
• If you will move the main machine to a different building, open the paper feed section and push the
cleaning blade lever to the left. This keeps the cleaning blade away from the drum while you move
the main machine.
• If you will move the main machine to a different location in the same building, it is not necessary to
set the lever to the left, and it is not necessary to disconnect the main machine from the roll feeder.
• Always push low on the roll feeder to move the main machine. If you do not do this, you can
twist and possibly cause damage to the main machine. Do not push on the main machine while
it is installed on top of the roll feeder.
• To prepare the main machine for transport to a different building, disconnect the main machine and
the roll feeder. Tape the drawer of the roller feeder so that it remains closed during transport.
• Lift the main machine with one person on each end of the main machine. Be sure to use the handles
in recesses on the sides of the main machine.
• To prevent developer and toner spill, never tilt the main machine more than 30° from the horizontal.
1. Installation
42
1