8. From the front, remove the board cover [1] (
x 2).
9. Connect the paper-cassette-unit connectors [2] (
x 2) to the roll feeder.
10. From the front, attach the harness clamps , , , .
11. Route the connector cable through the open clamps, then close the clamps (
x6).
12. Reattach the board cover, front cover, and rear plate of the roll feeder.
13. Reinstall the paper rolls, and close the drawer of the roll feeder.
14. Put the paper cassette in the paper cassette unit.
15. Set the Paper Size and Type for the Paper Cassette
• [Menu].
• [
]> "Paper Input"> [OK]
• [
]> "Paper Size"> "Paper Size: Tray 3"> [OK]
• [
] or [
]> Display the desired units (mm, inch.)
• [
] or [
]> Select the size in the left or right column> [OK]> "Programmed"
• [
] or [
]> "Paper Type: Tray 3"> [OK]
• [
] or [
]> Select the desired paper type.
• "Plain Paper" is the default setting. This setting is not required if plain paper is loaded in the
paper feed source.
• [OK]> "Programmed". The display returns to the previous level, so that you can do more settings.
• [Menu]> Standby mode
Paper Cassette (B853)
63
1
Summary of Contents for Neptune-P1
