Ricoh Neptune-P1, Service Manual

Page: 283 / 457

14 BpTr:OILEdge
Bypass: Translucent:
Outside Image Leading
Edge
[0.0 to -66/ -15/0.1 mA]
15 BpFm:ILEdge
Bypass: Film: Image
Leading Edge
[0.0 to -66/ -15/0.1 mA]
16 BpFm:OILEdge
Bypass: Film: Outside
Image Leading Edge
[0.0 to -66/ -15/0.1 mA]
17 CaILEdge
Cassette: Image Leading
Edge
[0.0 to -66/0/0.1 mA]
18 CaOILEdge
Cassette: Outside Image
Leading Edge
[0.0 to -66/0/0.1 mA]
2801 Init Devr Initialize Developer
This SP mixes the developer and initializes the ID sensor. Use this SP to mix the developer during
machine installation or after the developer has been replaced. The machine requires two packs
of developer. Two SP codes are provided for entering the lot numbers of both packages.
Note:
• Always enter the lot numbers with SP2801-2 and -3 before doing SP2801-1.
1 Initialize
Developer Initial Setting:
Execute Mixes developer and initializes the ID
sensor
2 Lot Number1 Lot Number 1 Lot number of the 1st packet.
3 Lot Number2 Lot Number 2 Lot number of the 2nd packet.
2803 CWClean:Str Corona Wire: Cleaning Start
Do this SP to clean the charge corona wire. This SP also moves the cleaning pad to the home
position. The cleaning requires about 20 sec. to complete.
2804 CWClwan:Int Corona Wire: Cleaning Interval
Sets the interval for charge corona wire cleaning.
Note: The wire is cleaned only when the hot roller temperature is below 50 °C (122°F).
[0 to 6/3/1 step]
0: None (no cleaning)
5. Service Tables
282
5