Ricoh Neptune-P1, Service Manual

Page: 276 / 457

• Inching control is done when the pressure roller temperature is above this setting (65
o
C
for example), but printing is prohibited until the pressure roller temperature reaches its
target temperature.
• Inching (idle rotation of the rollers) starts after the temperature rises above the hot roller
target temperature (SP1937 003).
• While the temperature is below 65
o
C copying (not printing) is possible before the
temperature of the pressure roller reaches its target temperature and inching starts.
1 Plain: Mode1 [60 to 180/100/5
o
C]
2 Plain: Mode2 [60 to 180/65/5
o
C]
3 Plain: Mode3
[60 to 180/60/5
o
C] 4 Plain: Mode4
5 Plain: Mode5
6 Trans.: Mode1 [60 to 180/130/5
o
C]
7 Trans.: Mode2 [60 to 180/100/5
o
C]
8 Trans.: Mode3
[60 to 180/60/5
o
C]
9 Trans.: Mode4
10 Trans.: Mode5
11 Film: Mode1
12 Film: Mode2
13 Film: Mode3
14 Film: Mode4
15 Film: Mode5
16 Pp:LTempCold Plain Mode: Low Temp Cold Start
When the machine determines that a cold start in a low-temperature environment has started,
the machine uses this setting to start the machine and ignores the paper thickness mode settings.
• When the prescribed time has elapsed after a cold start, temperature control returns to
the paper type and thickness settings.
• However, this low temperature cold start does temperature control for plain paper only,
not for either translucent paper or film.
[60 to 80/120/5
o
C]
SP1-xxx Feed
275
5