Idle Registration Roller Panel
1. Open the upper unit.
2. Side covers. (See p.112 "Side Covers".)
3. Toner hopper cover (See p.115 "Toner Hopper Cover".)
4. Disconnect the connector and ground wire [A] (
x 1,
x 1).
5. Idle registration roller panel [B] (
x 2)
• Remove the two rear screws [C] first and let the panel come down. Use a very short screwdriver
to remove the rear screws.
• Disconnect the panel from the stud screw on the right side first [D], then the left side. Do not
remove the stud screws.
Reinstallation
• Make sure that the mylar [C] is on the front edge of the exposure glass.
3. Replacement and Adjustment
116
3
Summary of Contents for Neptune-P1
