Side Covers
1. Raise the levers [A] on both sides of the machine to open the upper unit.
2. Remove the left small cover [B] (
x 2).
3. Remove the left upper cover [C] (
x 2).
• Push in the lever [A] to remove the cover.
4. Remove the left cover [D] (
x 3).
5. Do Steps 1,2 and 3 to remove the right covers.
Reinstallation
• Make sure that the upper unit is open.
• Always install the lower covers before the upper covers.
• Push in the levers [A] when you attach the upper covers.
3. Replacement and Adjustment
112
3
Summary of Contents for Neptune-P1
