Ricoh Neptune-P1, Service Manual

Page: 101 / 457

Seal Check and Removal
1. Check the two box seals [1] on the corners of the box and confirm that they are firmly attached.
• If you see “VOID” on the tapes or on the corners of the box this means that the seals have been
removed. If the "VOID" notations are visible, do not use the SD card for this installation. Contact
your sales division.
2. Remove the seals from both corners of the box. The silver "VOID" notations [2] become visible only
after you have removed the seals. This is normal.
Installation
1. Confirm that the machine is switched off and disconnected from its power source.
2. Disconnect the network cable if one is attached.
3. Remove the SD card slot cover (
 x1).
• Once again, confirm that the box is labeled "Data Overwrite Security Type D". On the side of
the box you should see "B735". If you install the incorrect version of this unit, the NVRAM must
be replaced.
4. Insert the DOS SD card into Slot 1.
5. Switch on the machine.
6. Confirm that the machine recognizes the DOS SD card.
• Push [Menu]. You should see "Memory Status Erase".
• "Memory Status Erase" does not appear if the machine does not recognize the SD card.
1. Installation
100
1