Ricoh Neptune-P1, Service Manual

Page: 248 / 457

SP1-xxx Feed
1001 LEdge Reg Leading Edge Registration
1 1st Roll
Adjusts the leading edge registration for printing. To move the image down
the page, increase the value.
[-10.0 to +10.0/ 0 /0.1 mm step]
2 2nd Roll
3 Cassette
5 By-pass Feed
1002 S-to-S Reg Side-to-Side Registration
1 1st Roll Adjusts the side-to-side registration for printing.
[-10.0 to +10.0/ 0 /0.1 mm step]
• To move the start position to the right, increase the value (+).
• To move the start position to the left, decrease the value (–).
Note: If you use paper 914 mm wide, adjust within the range of ±2
mm. If you set the adjustment outside this range, part of the image
will be cut off.
2 2nd Roll
3 Cassette
5 By-pass Feed
1105 FTemp Adj Fusing Temperature Adjustment
Be sure to switch the main power switch off and on after adjustment.
Cy Rdy Temp Copy Ready Temperature
1
Sets the copy ready fusing temperature. The setting is the difference from the target fusing
temperature that is set with SP1931. DFU
[0 to +20/10/1°C]
Copying can start at this temperature before the hot roller reaches its target temperature
(SP1931).
Low Power Mode
3
Sets the copy ready temperature for low power mode.
[80 to 150/90/1°C step]
FTemp Calib Fusing Temperature Calibration
5 Calibrates the scale for the fusing temperature settings. DFU
SP1-xxx Feed
247
5