Ricoh Neptune-P1, Service Manual

Page: 77 / 457

• Set the level on the left bottom support and then on the right bottom support.
• Use a wrench to turn the nut on the leg at each corner under the machine to adjust the height.
• The machine should be level (front to rear) on both sides to within ±0.15 mm/m.
2. Push the folder unit [1] against the back of the machine [2].
3. Make sure that the folder is aligned properly with the back of the main machine.
• At the top and on both sides, make sure that upper positioning bracket of the folder unit is
touching the back of the main machine . There must be no gap here.
• At the right bottom side, make sure that the lower positioning bracket of the folder is touching
the outer arm of the joint bracket of the main machine.
1. Installation
76
1