REXROTH Fv Series, Instruction Manual

Page: 118 / 222

Parameter setting Terminal is OFF Terminal is ON
[b1.00]=2，[E0.09]=4
（k1*VR1 + k3*（+I））
Inactive Inactive
[b1.00]=2，[E0.09]=5
（k2*VR2 + k3*（+I））
Reference channel
is k2*VR2 + k3*（+I） Reference channel
is k2*VR2 + k1*VR1
[b1.00]=2，[E0.09]=6
（k1*VR1）
Inactive Inactive
Fig.7-40: Switch between VR1 analog reference and +I analog reference
● 19: External fault N.O contact input
● 20: External fault N.C contact input
–
When an external fault signal is sent to the converter, the concreter
responses with ‘E.-St’ alarm and stops. This is to facilitate the mon‐
itoring and interlinking of the external devices.
● 21: External reset input
–
Same like reset with operating panel.
– Allows remote fault reset.
● 22: Communication control activated
–
Used to switch between control with operating panel and with com‐
munication, when [b1.02]=0.
– Used to switch between control with external terminals and with
communication, when [b1.02]=1.
E0.09
Source of analog setting reference frequency Factory Default 0
Setting range
0: k1*VR1
1: k2*VR2
2: k3* （+I）
3: k1*VR1 + k2*VR2
4: k1*VR1 + k3*（+I）
5: k2*VR2 + k3*（+I）
6: k1*VR1
(only active for -10 − +10 V
forward/reverse control)
Minimum unit 1
E0.10
VR1 channel amplification factor k1 Factory Default 1.00
Setting range 0.00 − 10.00 Minimum unit 0.01
E0.11
VR2 channel amplification factor k2 Factory Default 1.00
Setting range 0.00 − 10.00 Minimum unit 0.01
E0.12
+I channel amplification factor k3 Factory Default 1.00
Setting range 0.00 − 10.00 Minimum unit 0.01
E0.13
Reference frequency curve selection Factory Default 0
Setting range 0 − 15 Minimum unit 1
E0.14
Analog channel filter time Factory Default 0.100s
Setting range 0.000 − 2.000s Minimum unit 0.001s
Bosch Rexroth AG DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv
116/219
Parameter Settings