REXROTH Fv Series, Instruction Manual

Page: 129 / 222

– Simple PLC control stops after one cycle.
● 2: Mode 2
–
Converter runs repeatedly, will be stopped by stop commands.
● 3: Mode 3
–
Converter keeps running at the set frequency of the last phase af‐
ter one cycle.
E2.22
PLC time factor Factory Default 1
Setting range 1 − 60 Minimum unit 1
The actual run time of each stage is ‘Set time * parameter ‘PLC time factor’
[E2.22]’.
E2.23
Stage 1 action selection Factory Default 0
Setting range 0 − 31 Minimum unit 1
● The set frequency of stage 1 is defined with parameter ‘Multi-speed fre‐
quency 1’ [E2.06].
● Used to define running direction and acceleration/deceleration time of
stage 1.
–
bit4
–
0: Forward
– 1: Reverse
– bit3 and bit2
–
00: set with parameter ‘Acceleration time 1’ [b1.09]
– 01: set with parameter ‘Acceleration time 2’ [E2.00]
– 10: set with parameter ‘Acceleration time 3’ [E2.02]
– 11: set with parameter ‘Acceleration time 4’ [E2.04]
– bit1 and bit0
–
00: set with parameter ‘Deceleration time 1’ [b1.10]
– 01: set with parameter ‘Deceleration time 2’ [E2.01]
– 10: set with parameter ‘Deceleration time 3’ [E2.03]
– 11: set with parameter ‘Deceleration time 4’ [E2.05]
● The data format of this parameter is shown in .
bit4 bit3 bit2 bit1 bit0
Fig.7-49: Data format of parameter [E2.23]
E2.24
Stage 1 running time Factory Default 0.0s
Setting range 0.0 − 5000.0s Minimum unit 0.1s
Used to set the running time of stage 1, related parameter ‘PLC time factor’
[E2.22].
E2.25
Stage 2 action selection Factory Default 0
Setting range 0 − 31 Minimum unit 1
E2.26
Stage 2 running time Factory Default 0.0s
Setting range 0.0 − 5000.0s Minimum unit 0.1s
DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv Bosch Rexroth AG 127/219
Parameter Settings