REXROTH Fv Series, Instruction Manual

Page: 114 / 222

● If Xi (i=1 − 8) terminal is set to 7, “3-wire control” is selected.
● K2 is for direction selection: 0: forward; 1: reverse.
● K1 is the N.O switch, and K3 is the N.C switch. K1 and K3
are activated with pulse edges.
E0.01
Terminal X1 Factory Default 0
Setting range 0 − 22 Minimum unit 1
E0.02
Terminal X2 Factory Default 0
Setting range 0 − 22 Minimum unit 1
E0.03
Terminal X3 Factory Default 0
Setting range 0 − 22 Minimum unit 1
E0.04
Terminal X4 Factory Default 0
Setting range 0 − 22 Minimum unit 1
E0.05
Terminal X5 Factory Default 0
Setting range 0 − 22 Minimum unit 1
E0.06
Terminal X6 Factory Default 0
Setting range 0 − 22 Minimum unit 1
E0.07
Terminal X7 Factory Default 0
Setting range 0 − 22 Minimum unit 1
E0.08
Terminal X8 Factory Default 0
Setting range 0 − 22 Minimum unit 1
8 multifunction digital input terminals (X8 can be used as a high-speed pulse
input terminal) are available with PNP and NPN input modes and with either
internal or external power supply.
●
0: Inactive
–
The converter is inactive even if there is input signal. Unused ter‐
minals are suggested to be set to 0 (no active) to avoid malfunc‐
tion. Multiple selection is possible.
● 1: Multi-speed control terminal 1
● 2: Multi-speed control terminal 2
● 3: Multi-speed control terminal 3
● 4: Multi-speed control terminal 4
16 multi-speeds are available with the combinations of the four
terminals.
For example, if external terminals X1, X2, X3 and X4 are set as multi-speed
terminals: [E0.01]=1, [E0.02]=2, [E0.03]=3 and [E0.04]=4, multi-speed control
can be set with external switches. Run, Stop and direction can be set with
FWD and REV, as shown in fig. 7-35 "Multi-speed control wiring" on page
113 .
Bosch Rexroth AG DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv
112/219
Parameter Settings