REXROTH Fv Series, Instruction Manual

Page: 128 / 222

E2.16
Multi-speed frequency 11 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
E2.17
Multi-speed frequency 12 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
E2.18
Multi-speed frequency 13 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
E2.19
Multi-speed frequency 14 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
E2.20
Multi-speed frequency 15 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
Parameters [E2.06] − [E2.20] are used to set the speeds (frequencies) in
multi-speed control and simple PLC control.
●
Multi-speed control
–
16 multiple speeds can be set via multi-speed control terminals, to‐
gether with forward/reverse control terminals (FWD-COM and
REV-COM) and acceleration/deceleration terminals.
–
Running time of each speed is decided by the hold time of
corresponding logic combination.
– Output frequency is decided by parameters [E2.06] − [E2.20]
corresponding to each speed. For details of multi-speed run‐
ning, see parameters [E0.01] − [E0.08].
● Simple PLC control
–
Automatic control according the current acceleration/deceleration
time, output frequency, running time and rotation direction. One cy‐
cle of simple PLC control is shown in fig. 7-48 "Simple PLC control"
on page 126 .
Fig.7-48: Simple PLC control
f1 − f15 are set with parameters [E2.06] − [E2.20], and T1 − T15
are set with parameters [E2.22] − [E2.52].
E2.21
PLC control mode Factory Default 0
Setting range 0, 1, 2, 3 Minimum unit 1
● 0: Inactive
–
Simple PLC control is inactive.
● 1: Mode 1
Bosch Rexroth AG DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv
126/219
Parameter Settings