REXROTH Fv Series, Instruction Manual

Page: 108 / 222

Group S3: Run Parameters
S3.00
Jog frequency Factory Default 5.00 Hz
Setting range 0.00 − b1.05 Minimum unit 0.01 Hz
S3.01
Jog acceleration time Factory Default 5.0s
Setting range 0.1 − 3600.0s Minimum unit 0.1s
S3.02
Jog deceleration time Factory Default 5.0s
Setting range 0.1 − 3600.0s Minimum unit 0.1s
● Parameter [S3.00] is used to set jog frequency.
● Parameters [S3.01] and [S3.02] are used to define the jog acceleration
and deceleration time, as shown in fig. 7-26 "Jog frequency setting" on
page 106 .
Fig.7-26: Jog frequency setting
● The converter allows jog when power is on. Jog can be set via operating
panel or external computer.
Jog is inactive in torque control mode.
S3.03
Skip frequency 1 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
S3.04
Skip frequency 2 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
S3.05
Skip frequency 3 Factory Default 0.00 Hz
Setting range b1.07 − b1.06 Minimum unit 0.01 Hz
S3.06
Skip frequency range Factory Default 0.00 Hz
Setting range 0 − 30.00 Hz Minimum unit 0.01 Hz
● Three skip frequencies may be set to avoid mechanical resonance
points
–
If the output frequency falls within the skip frequency range, the
output frequency will be automatically set to the upper or lower limit
of the skip frequency range.
Bosch Rexroth AG DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv
106/219
Parameter Settings