Remote Control Commands
R&S
®
SMB100A
471
Operating Manual 1407.0806.32 ─ 21
Setting parameters:
<PS>
8 ASCII characters
Note:
An eight-digit value must always be set. Blank spaces, if
any, must also be entered, otherwise the value will not be
accepted.
Special characters in the program service name are entered with
a leading back slash (\) followed by the decimal code of the spe-
zial character according to tabe E1 of CENELEC.
Example:
STER:DIR "RT=02,0,test text with \217"
217 denotes the German ü.
Example:
STEReo:DIRect "PS=RDS Test"
Sets the program service name to be transmitted to "RDS Test".
Example:
STEReo:DIRect? "PS"
Response:
"RDS Test"
STEReo:DIRect
"PS-TABLE=<Table>"
STEReo:DIRect?
"PS-TABLE"
Selects the character set table tobe used for the display of the RDS program service
(PS) name in the receiver.
The information concerning the character set is transmitted in segment 0 of the PS.
Segment 0 is repeatedly transmtted if the value for
PS-TABLE
> 0. For
PS-TABLE
=0
no information concerning the character set is transmitted.
Setting parameters:
<Table>
0 | 1 | 2 | 3
0
no information concerning the character set table in the PS
1
table E.1 is used
2
table E.2 is used
3
table E.3 is used
Example:
STEReo:DIRect "PS-TABLE=2"
The information concerning the character set is transmitted in
segment 0 of the PS in group 0A. To this end, segment 0 is
transmitted repeatedly. At the first transmission segment 0 con-
tains the information about the character set, at the second
transmission segment 0 contains the first two characters of the
PS.
STEReo:DIRect
"PTY=<PTY>"
STEReo:DIRect?
"PTY"
Sets or reads the program type (PTY).
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
