Preparing for Use
R&S
®
SMB100A
37
Operating Manual 1407.0806.32 ─ 21
To assign the IP address manually on the remote computer
► Obtain the necessary information from your network administrator. If you use more
than one LAN connector, you need separate address information for each connec-
tor.
For information on how to perform the configurations, refer to the documentation of
the operating system the remote computer uses.
2.6.3 Using Computer Names
In a LAN that uses a DNS server (Domain Name System server), each PC or instru-
ment connected in the LAN can be accessed via an unambiguous computer name
instead of the IP address. The DNS server translates the host name to the IP address.
This is especially useful when a DHCP server is used, as a new IP address may be
assigned each time the instrument is restarted.
Each instrument is delivered with an assigned computer name, but this name can be
changed.
The default instrument name is a non-case-sensitive string that follows the syntax
rs<instrument><serial number>
.
The serial number can be found on the rear panel of the instrument. It is the third part
of the device ID printed on the bar code sticker:
Querying and changing a computer name
1. Press the "Setup" key and select "Network Settings".
The computer name is displayed under "Hostname".
2. Press the "Setup" key, select "Protection" and enable the "Protection Level 1".
The default password is
123456
.
The parameter "Hostname" in the "Network Settings" dialog is now enabled for
configuration.
3. Change the "Hostname".
2.7 Remote Access via an External Controller
The R&S
SMB can be remote accessed from a remote computer (external controller)
via a network link. This allows convenient operation of the instrument from the desktop
although the instrument is integrated in a rack somewhere else.
Remote Access via an External Controller
