Instrument Function
R&S
®
SMB100A
138
Operating Manual 1407.0806.32 ─ 21
5.3.2.2
Setting the RF Frequency
To change the RF frequency, press the FREQ key and enter the desired frequency.
Changes to the RF frequency have an immediate effect (without confirmation with the
ENTER key) on the output signal.
RF Freq
Enters the RF frequency, considering the frequency offset.
Note:
The SCPI command sets the level of the "Freq" display, that means an entered
frequency offset and multiplier factor are considered in the frequency value.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]
5.3.2.3
RF Frequency Dialog
The combined "RF Frequency / Phase..." dialog contains the parameters required for
configuring the frequency and settings like a frequency offset, or a multiplier factor of
an externally connected multiplier, see
Chapter 5.3.2.4, "Frequency Settings"
Furthermore, the dialog provides additional settings parameters which are described
in:
●
5.3.2.4
Frequency Settings
Access:
► Select "RF > config... > RF Frequency > Frequency/Phase".
In the upper section of the combined "RF Frequency / Phase ..." settings dialog,
you can configure the frequency of the RF signal.
RF Block
