R&S SMB100A, Operating Manual

Page: 363 / 528

Remote Control Commands
R&S
®
SMB100A
348 Operating Manual 1407.0806.32 ─ 21
Parameters:
<Impedance> HIGH | G600
HIGH
> 100 k0hm to ground
*RST:
HIGH
Example: INP:MOD:IMP HIGH
sets > 100 kOhm to ground.
Manual operation: See "Ext. Impedance" on page 201
[:SOURce<hw>]:INPut:MODext:WIGNore <SuppressState>
Ignores warnings concerning an overload of the modulation signal input.
This setting is not affected by an instrument preset
*rst
or the and Save/Recall func-
tion. Only the factory preset resets this setting.
Parameters:
<SuppressState> 0 | 1 | OFF | ON
*RST:
0
Example: INP:MOD:WIGN ON
suppresses the overvoltage warnings.
Manual operation: See "Ignore Overvoltage Warning" on page 202
[:SOURce]:INPut:TRIGger:SLOPe <Slope>
Sets the polarity of the active slope of an externally applied trigger signal at the trigger
input (BNC connector at the rear of the instrument).
The setting is effective for both inputs at the same time.
Parameters:
<Slope> NEGative | POSitive
*RST:
POSitive
Example: INP:TRIG:SLOP NEG
Activates the falling slope of the external trigger signal at the
trigger input.
Manual operation: See "Ext. Trigger Input Slope" on page 182
7.13.6 SOURce:LFOutput Subsystem
The
SOURce:LFOutput
subsystem contains the commands for setting the LF signal
source in CW and Sweep mode and for analog modulation.
SOURce Subsystem