Remote Control Commands
R&S
®
SMB100A
468
Operating Manual 1407.0806.32 ─ 21
STEReo:DIRect
"MS=<Flag>"
STEReo:DIRect?
"MS"
Sets or reads the music/speech flag.
The flag signals whether music or speech is being transmitted.
Setting parameters:
<Flag>
M | S
Example:
STEReo:DIRect "MS=M"
The music/speech flag is set to "M". This signals that music is
currently transmitted.
Example:
STEReo:DIRect? "MS"
Response:
"M"
STEReo:DIRect
"MPX-DEV=<Deviation>"
STEReo:DIRect?
"MPX-DEV"
(for documentation reasons only)
Sets the MPX frequency deviation (max. deviation).
instead.
Setting parameters:
<Deviation>
A five-digit value must always be set. Leading zeros, if any, must
also be specified.
Range:
00000 to 10000 (ASCII coded decimal numbers),
corresponding to 0 Hz to 100 kHz
Example:
STEReo:DIRect "MPX-DEV=00201"
Sets the MPX frequency deviation to 2.01 kHz.
Example:
STEReo:DIRect? "MPX-DEV"
Response:
"00201"
STEReo:DIRect
"PI=<PI>"
STEReo:DIRect?
"PI"
Sets or reads the RDS program identification (PI) code.
Setting parameters:
<PI>
Note:
A four-digit value must always be set. Leading zeros, if
any, must also be specified, otherwise the value will not be
accepted.
Range:
0000 to FFFF (ASCII coded hexadecimal num-
bers)
Example:
STEReo:DIRect "PI=1234"
The program identification code to be transmitted is set to
"1234".
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
