Quantum DXi4701, User Manual

Page: 338 / 440

Chapter 9: DXi4701 Configuration
System
312 Quantum DXi4701 User’s Guide
• NATed - Select the check box if the IP address of the DXi is
translated by a firewall to a NAT IP address when the DXi
communicates to the outside world.
• NAT IP Address - The IP address used to access the DXi from the
public network. The router that connects the DXi to the Internet
performs Network Address Translation that maps the IP address
of the DXi to the NAT IP address, providing a valid replication
interface for a source DXi.
6 Select the check box for each type of network traffic allowed on the
interface (segmentation):
Note: At least one interface must allow management traffic.
Note: If the DXi is configured for source or target replication, you
should configure at least one interface to allow replication
traffic (select Repl or Any ) before applying changes to
network settings.
Note: If you configure segmentation for non-bonded interfaces
(Ethernet ports) that are on the same subnet, all traffic will
use the lowest numbered Ethernet port first, no matter
how segmentation is configured. To avoid this issue, create
bonded interfaces, and then select the desired traffic type
for each bonded interface.
• Mgmt - Select to allow management traffic.
• Repl - Select to allow replication traffic.
• Data - Select to allow data traffic.
• Any - Select to allow all types of traffic (management,
replication, and data).
7 Click Update to save the changes you made to the IP Address table.
(Clicking Update does not yet apply the new network settings to
the DXi4701.)
Click
Delete to remove IP address information for the selected
interface. Or click Undo to revert all current IP Address Table
changes to the last update.