Quantum DXi4701, User Manual

Page: 188 / 440

Chapter 6: DXi4701 Replication
Actions
162 Quantum DXi4701 User’s Guide
If a replication job is currently in progress, the system continues to
replicate the current block of data. The process of replicating the
current block can take up to 15 minutes to complete. After the
block has completed replication, the system pauses replication.
Note: If you pause a replication job that is in process, a Failure
event is logged in the replication report (see Reports on
page 163).
• Click Resume next to a target to resume all incoming and outgoing
replication and failback traffic to that target.
If a replication job was in progress when replication was paused,
the replication job continues.
Replication State
The replication state applies to all NAS shares or VTL partitions on the
DXi4701 that are eligible for replication (that is, all deduplicated shares
or partitions).
Note: The Replication Actions page may appear busy for a few
moments when enabling or disabling the replication state.
Wait for the process to complete before performing other
actions.
• Click Enable to enable replication for all shares or partitions.
• Click Disable to disable replication for all shares or partitions.
If a replication job is currently in progress, the system continues
until the entire replication job is complete. After the replication job
has completed, the system disables replication. The system will not
be able to replicate data for any shares or partitions until you click
Enable .
Note: To disable replication for a single share or partition, select it
on the Replication > Send page and click Edit . Clear the
Enable replication and the Enable scheduled replication
check boxes, and then click Apply . For more information,
see Replication Send on page 122