Quantum DXi4701, User Manual

Page: 279 / 440

Chapter 9: DXi4701 Configuration
Replication Configuration
Quantum DXi4701 User’s Guide 253
Caution: For encryption, select None or 128-bit if you are
sending data to a DXi running a system software
version prior to DXi 2.1 Software.
4 In the Source IP box, enter the IP address that is used to uniquely
identify the source DXi to the target. This may be different than the
actual network IP address of the source DXi.
If the target system is at DXi 2.1 Software or higher, the
Source IP
field is not required. If the target system is at DXi 2.0.1.x Software
or below, then you must enter the IP address by which the target
system recognizes the source system. The default value is 0.0.0.0 .
Note: The Source IP field does not accept fully qualified domain
names. You must enter a valid IP address. Make sure this IP
address is configured in the allowable sources list on the
target DXi.
Note: When configuring segmented network interfaces, if the
source DXi replication, data, and management interfaces
are on the same subnet, you must add a host route on the
source DXi to make sure the replication interface is
correctly selected when replicating data to the target DXi
(see Understanding Interface Routing on page 315).
5 Click Apply .
Note: The new target is not automatically added to existing
replication schedules. You must add or edit scheduled events to
schedule replication to the new target (see Scheduler on
page 292).
Editing a Replication
Target
Edit a replication target to change encryption options or the source IP
address.
To edit a replication target:
1 Under Target DXis , select the target and click Pause to pause
replication.