Chapter 5 - System Setup
5-15
PL-5910 Series User Manual
Suspend Type
Designates the type of suspend method used. The available settings are [Stop Grant]
and [PwrOn Suspend]. The factory default setting is [Stop Grant] and recommended
for most users.
Suspend Mode
When enabled, designates the period of time before all devices except the CPU are shut
down. The available settings are [1Min], [2Min], [4Min], [8Min], [12Min], [20Min],
[30Min], [40Min], [1Hour] and [Disabled]. The factory default setting is [Disabled]
and recommended for most users.
HDD Power Down
After the hard disk's motor stoPL, this setting designates the length of time until the PL
unit enters energy-saving mode. The available selections are [1Min], [2Min], [3Min],
[4Min], [5Min], [6Min], [7Min], [8Min], [9Min], [10Min], [11Min], [12Min], [13Min],
[14Min], [15Min] and [Disabled]. [5Min] is factory set and recommended for most
users. If the Power Management setting is set to other than [User Define], this setting
can not be changed.
Wake-Up by PCI Card
Enables/disables waking up the PL unit's system via an expansion board signal. The two
selections available are [Disabled] and [Enabled]. The [Disabled] selection is factory
set.
**Reload Global Timer Events**
This feature sets the event that reloads the amount (period) of PL unit idle time prior to
changing to energy-saving mode. Thus, when an event occurs for any of the items in this
area that are set to [Enabled], the PL unit will recover from energy-saving
mode.[Enabled/Disabled] is possible for the following settings: [Primary IDE 0], [Pri-
mary IDE 1], [FDD], [COM], [LPT Port], [PCI PIRQ[A-D]#]. Factory settings are all
[Disabled].
