Chapter 4 - Installation and Wiring
4-9
PL-5910 Series User Manual
3) Loosen and remove the middle
three screws from the terminal strip.
Align the crimp terminals with each
screw hole, and tighten the screws.
• The colors used in these
figures are for the cable
which came with the PL.
• This power cable is de-
signed only for AC100V/
AC115V use. Any other
power level should use
its own specially de-
signed cable.
4) Reattach the terminal strip’s trans-
parent cover and tighten both the
attatchment screws.
Crimp Terminal Types :
V1.25-3, by J.S.T. or equiva-
lent (JIS standard part num-
ber : RAV1.25-3)
• Crimp terminals must be the
same as shown below.
• Check that each crimp termi-
nal is correctly positioned and
secure it in place. Required
torque is 0.5 to 0.6N•m.
PL5910-T11, PL5911-T11
Terminal Block Cover
Attachment Screw
2) Next, loosen both attachment
screws and swing the plastic termi-
nal block cover 90
o
to expose the
terminal block screws.
