Chapter 5 - System Setup
5-7
PL-5910 Series User Manual
Quick Power On Self Test
This setting determines whether the quick self test is performed when the power is
turned on. The available settings are [Disabled] or [Enabled]. The factory default setting
is [Enabled] and is recommended for most users.
First/ Second/ Third/ Fourth Boot Device
The selections for the search drive sequence of the operating system.
The available settings are [Floppy], [HDD-0], [SCSI], [CDROM], [HDD-1], [HDD-
2], [HDD-3], [USB-FDD], [USB-ZIP], [USB-CDROM], [USB-HDD], [LAN], and
[Disabled]. Factory settings are: First: [Floppy], Second: [HDD-0], Third: [CDROM],
Fourth: [Disabled].
Swap Floppy Drive
This setting swaps Drives A and B. The available settings are [Disabled] or [Enabled].
The factory default setting is [Disabled] and is recommended for most users.
Boot Up Floppy Seek
The setting checks whether the floppy disk drive is installed during the system boot-up
process. The available settings are [Disabled] or [Enabled]. The factory default setting
is [Enabled] and is recommended for most users.
Boot Up Numlock Status
This setting specifies the Numlock key status upon the startup. The available settings
are [On] and [Off]. The factory default setting is [On] and is recommended for most
users.
Typematic Rate Setting
The setting specifies the keyboard speed used when repeating characters.
The available settings are [Enabled] and [Disabled]. The factory default setting is
[Disabled].
Typematic Rate (Chars/ Sec)
This setting specifies the actual typematic rate (repeated character input per second)
when the [Typematic Rate Setting] option is set to [Enabled]. The settings are used to
determine how many repeats are performed in one second. The factory default setting is
[6].
The available settings are [6], [8], [10], [12], [15], [20], [24], and [30].
