Chapter 5 - System Setup
5-12
PL-5910 Series User Manual
USB Keyboard Support
Select [Enabled] or [Disable] if your system contains a USB controller and you
wish to use a USB keyboard. The available settings are [Disabled] and
[Enabled]. The factory default setting is [Auto]. If, however, the USB Controller
is set to [Disabled], this setting cannot be changed.
USB Mouse Support
This setting allows you to connect a USB mouse, even if the OS does not
support it. It allows the BIOS to use a mouse driver and treats the mouse as if it
were a PS/2 type mouse.The available settings are [Disabled] and [Enabled].
The factory default setting is [Auto]. If, however, the USB Controller is set to
[Disabled], this setting cannot be changed.
Init Display First
When both a PCI and an AGP display boards are installed, this setting
designates which will have first priority. Settings are [PCI slot] or [Onboard/
AGP]. The factory default setting is [PCI slot].
Onboard LAN
Disables/enables the LAN connector. The available settings are [Disabled] and
[Enabled]. The factory default setting is [Enabled].
IDE HDD Block Mode
This setting determines whether to enable the Block Mode on the HDD supporting the
Block Mode. The available settings are [Disabled] and [Enabled]. The factory default
setting is [Enabled] and is recommended for most users.
Onboard FDC Controller
Designates whether the PL unit's FDD (Floppy Disk Drive) controller is enabled
or disabled. Settings available are [Disabled] or [Enabled]. The [Enabled]
selection is factory set.
Onboard Serial Port 1
Designates the PL unit's Serial Port 1 I/O address. The selections include
[Disabled], [3F8/IRQ4], [3F8/IRQ11], [2F8/IRQ3], [2F8/IRQ10],
[3E8/IRQ4], [3E8/IRQ11], [2E8/IRQ3] and [2E8/IRQ10].
The [3F8/IRQ4] selection is factory set and recommended for most users.
Onboard Serial Port 2
Designates the PL unit's Serial Port2 I/O address. The selections include
[Disabled], [3F8/IRQ4], [3F8/IRQ11], [2F8/IRQ3], [2F8/IRQ10], [3E8/
IRQ4], [3E8/IRQ11], [2E8/IRQ3] and [2E8/IRQ10].
The [2F8/IRQ3] selection is factory set and recommended for most users.
