Chapter 2 - Specifications
2-11
PL-5910 Series User Manual
2.4
PL Part Names and Features
A: Display
Display output area. The built-in VGA control-
ler supports PC compatible architecture.
B:Touch Panel
This high-resolution analog touch panel allows
you to configure a keyboard-less system.
C: Front Maintenance Cover
Open this cover to access the Keyboard I/F, Reset
Switch and connect the optional FDD unit.
D: Power Lamp LED (POWER)
The status of the lamp changes according to the
alarm type detected by the RAS feature.
2.3.5 RAS Interface
E: Hard Disk Access LED (DISK)
Lights during accesses to the hard disk.
F: FDD Front Face Blank Panel
Remove this cover to install the optional FDD Unit.
G:Keyboard Connector
A PS/2 compatible keyboard is connected here.
H: USB Connector (USB2)
To use the USB connector, you must install Windows
98 (SR2).
I: Hardware Reset Switch (RESET)
J:Touch Panel I/F Selector Switch (T MODE)
Select “U”: Touch data is sent via USB I/F.
Select “S”: Touch data is sent via serial I/F (COM4).
Factory setting is “S” (Serial).
K: IDE I/F Cover
To connect the optional CD-ROM drive unit (PL-
DK200) or the RS-232C/RS-485 Adapter remove
this cover and use this connector.
L: FDD Rear Face Blank Panel
Remove this cover to install the optional FDD
Unit.
M:Power Switch (POWER)
Turns the PL unit’s power ON or OFF.
N:Power Terminal Block
Connect the PL unit’s AC100V/DC24V power
cord terminals here.
Front
C
A B
E
D
G
H
F
I
K
M
L
N
(Inside Front Maintenance Cover)
Rear
J