2-38
Maintenance Utilities
VU-ACD™/100 Maintenance Guide – Host/DOS
2.6.1.2
5ESS Configuration Assignment
Step
Prompt
Action
1
VIEW/MODIFY 5ESS NODE CONFIGURATION for Node <n>
1) Node Description
5ESS
2) Port(s)
/dev/ttyi2A
3) Baud rate
9600
4) Switch version number
12/13
Select a parameter to modify or “q” to
quit:
Type the number corresponding to the con-
figuration parameter you wish to change and
press
Enter
.
?
Steps 2 thru 5 below describe the procedures for changing each parameter listed in the
View/Modify 5ESS Configuration Menu.
2
1) Node Description
5ESS
Type
1
and press
Enter
to change the Node
Description.
Node Description (1 to 20 characters) [default: 5ESS ]
Type a descriptive name for this node (up to
20 alphanumeric characters); press
Enter
to
change the Node Description.
3A
2) Port
/dev/ttyi1A
Type
2
and press
Enter
to change the PAD
Port assignment.
3B
VIEW/MODIFY 5ESS NODE CONFIGURATION for Node <n>
(NOTE: Up to 4 Ports can be configured fro this node)
5ESS Port # <n>
List of configured serial tty devices
Note: although configured, devices may not
be available to use. Ensure that a serial device
is available prior to assigning it.
ttyi1B
ttyi1H
ttyi2A
ttyi2B
ttyi2d
ttyi2e
ttyi2f
ttyi2g
Enter the serial port, ‘R’ to remove
default or ‘D’ when done
[default: ttyi2A ] : [ ]
NOTE: Refer to Table 2.3 for a complete listing of
DigiBoard serial port nomenclature.
Complete one of the following:
•
To assign a port proceed to Step 3C.
•
To Delete the default port proceed to
Step 3D
•
To quit type
D
and press
Enter
. Return to
Step 3B.
3C
[default: ttyi2A ] : [ ]
Type the serial port number to be assigned for
this node and press
Enter
.
Return to Step 3B.
