Perimeter Technology VU-ACD /100, Maintenance Manual

Page: 53 / 192

2-35
VU-ACD™/100 Maintenance Guide - Host/DOS Maintenance Utilities
Step Prompt Action
List of configured serial tty devices
Note: although configured, devices may not
be available to use. Ensure that a serial device
is available prior to assigning it.
tty1B
ttyi2d ttyi1H
ttyi2e ttyi2A
ttyi2f ttyi2B
ttyi2g
Enter the serial port for the DMS-100 PAD:
[ ]
NOTE: Refer to Table 2.3 for a complete listing of
DigiBoard serial port nomenclature.
Type the serial port number to be assigned to the
PAD and press
Enter .
6
4) Baud rate Type
4
and press
Enter
to change the Baud rate.
7 Baud rates supported are:
1) 4800
2) 9600
3) 19200
Select baud rate: [ ]
Type a number corresponding to the desired baud
rate and press
Enter . The View/Modify DMS
Node Configuration Menu reappears.
Proceed to Step 14.
-or-
Choose another configuration parameter to
change or proceed to Step 32.
For LAN Connection
8 2) Connection Type Type
2
and press
Enter
to change the Connection
Type for your LAN connection.
9
MODIFY DMS NODE CONFIGURATION
for Node <n>
The PADs supported are:
1) MEMOTEC
2) CX800
3) DCA
4) LAN
Select option 1 if using a Memotec PAD
Select the type of PAD:[ ]
Type the number corresponding to the type of
PAD/Connection used in this system and press
Enter .
If you selected
4) LAN
continue with next step.
-or-
All other options go to Step 5.
The View/Modify DMS Node Configuration
Menu reappears.
Choose another configuration parameter to
change or proceed to Step 32.
10 3) TCP/IP Port value Type
3
and press
Enter
to change the Port value
for your LAN connection.
11
Enter the TCP/IP Port ID Value of the MIS
connection for the DMS-100 Input
(Acceptable values are between 1 and 65535):
[ }
Note: Only one TCP/IP Port can be configured
for this Node.
Type the appropriate port number and press
Enter .
12
4) DMS-100 IP Address Type
4 and press Enter to change the IP Address.
13 Enter the IP Address of the DMS-100 Input
(Example: 151.175.120.130): [ ]
Type the appropriate IP Address and press
Enter
.
Proceed with Step 14. The View/Modify DMS
Node Configuration Menu reappears.
Choose another configuration parameter to
change or proceed to Step 32.